Jump to content

stdape

Member
  • Content Count

    348
  • Joined

  • Last visited

  • Feedback

    N/A

Community Reputation

72 Excellent

About stdape

  • Rank
    17 Jewel

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Thanks Simon. Will note number down.
  2. If off E-Bay a lot of watches will end up in the spares tin, as i have found out myself. And the bits that fly off never to be found again ! Or is thatjust me if you can look for the Movement Calibre if it has one. Usually on the Movement somewhere, including under the Dial, and by Balance Wheel. Not all have them which is a pain. But if stuck pictures of the Movement back and front (without dial), posted in the forum, might get some response.
  3. I do not have the capability of making one. Will wait and see as in no hurry at present.
  4. Ah thank you for that, answers that question.
  5. Dare i ask if you would give it me . It is a lovely Pocket Watch, something that old and still going.
  6. Thanks for that, i see a few but prices seemed high. There is one in CousinsUK for £3.50 bit is for the 3602a was not sure if was same as 3602. The link seems more reasonably priced, only a cheap pocket watch, but the movement seems a nice quality.
  7. found this http://www.fixya.com/support/t3786980-timer_pulsar_watch_not_line_up_12_when not sure if u seen or it will work but good luck
  8. You got to much money lol
  9. Would like to add in the Bestfit Catalogue has 2739 for the Staff
  10. Obtained few watches as spares & Repair, one being a Molnia 3602 Pocket Watch, which as usual Balance Staff is broke i know the part is U3210, but finding hard to source, can anyone tell me if the 3602A is the same staff ? . O
  11. Never noticed that is a picture as purchased. It is a good quality movement, solid, but the nightmare broken balance shaft is reason for asking if anyone knows the Calibre. I will take balance out and adjust the spring. Thanks for replies. i did know it was to do with Dennison, and from what i make out, they did not make for long.
  12. Trys again https://www.dropbox.com/s/hhakwwsu6j5ik2u/DSCN0530.JPG?dl=0 https://www.dropbox.com/s/8yiqbie5bma0j1b/DSCN0532.JPG?dl=0
  13. OK not news for most But otherwise i have lost a screw for a ST69 movement the one for the Pallet Fork Holder. Would anyone have one in there pile of bits?
×
×
  • Create New...